DodgeTalk Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
My 04 intrepid 2.7 is throwing p0016 and p0344 (cam and crank sensors). The engine won’t go above 2400 RPM’s, like it's in limp mode. Also it takes awhile for me to start my car. Pretty much the exact same story tons of other people online have posted, including replacing those sensors.

I have seen tons of posts online with people talking about replacing those sensors multiple times for this car. And I found a lot of posts with people claiming to have fixed it then the code(s) returns awhile later, even after a refresh of the PCM. There has got to be a root issue. What has worked for people here?
 

·
Registered
Joined
·
179 Posts
Blow up the 2.7L and toss in a 3.5L High Output and a PCM from a 300m sepcial.

But really. A few people I know that have had this happen to after their 3rd set of sensors, PCM reflash and TCM reflash they just swap out the engine wire harness.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top