DodgeTalk Forum banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
1,539 Posts
Discussion Starter #1
These are the options that I was asked.

Black smoke, sputtering effect Polyethylene (PE)
Polypropylene (PP)
Acrylonitrile Butanadiene Styrene (ABS)
Polyvinyl Chloride (PVC)
Polyurethane (TPUR)

I am curious since I am going to attempt to a plastic weld on my bumper, Im hoping it has some life in it!
 

·
Registered
Joined
·
11,180 Posts
Should be stamped on it somewhere....not sure where though.
 

·
ASE approved
Joined
·
8,862 Posts
There are only 2types of plastic in AZ if you lived here I could tell you exactly what type you have. We only have broken, and not broken yet. The sun here is brutal on anything plastic.
 

·
Registered
Joined
·
130 Posts
Yes! Subscribed to this! There is a barcode on back side of bumper cover you can try and look up? In my opinion I'd expect it to be pp since its so widely used on hard plastic parts, like school lunch trays for example.

Sent from my EVO
 

·
Victims arent we all
Joined
·
1,826 Posts
had a damaged srt bumper cover,,,the paint guy smoothed out the cracks and plastic welded it,,,, perfect ,,,
 

·
Registered
Joined
·
1,539 Posts
Discussion Starter #6
had a damaged srt bumper cover,,,the paint guy smoothed out the cracks and plastic welded it,,,, perfect ,,,
That gives me hope that I can save mine, I am buying the new reinforcement bar on tommorow and starting over again :rolleyes:
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top