DodgeTalk Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
660 Posts
Discussion Starter · #1 ·
I am thinking I may have a warped rear rotor? But not sure yet. When braking I feel slight vibration in the seat. I will have to get my dial indicator on them to check. I know the problems are usually the fronts. But I just put Hawk LTS / Power Slots up front. Rotor runout is .003 and .005.( 3 and 5 thou)
Just wondering how many out there have warped the rear rotors?
Thanks.
 

·
Registered
Joined
·
252 Posts
If You Haven't Replaced Them Yet It Could Be That Or The Might Have Rusted Out On The Back Side.
 

·
Registered
Joined
·
660 Posts
Discussion Starter · #3 ·
If You Haven't Replaced Them Yet It Could Be That Or The Might Have Rusted Out On The Back Side.
The rears are slotted / dimpled ebc's. Little over 2 years old. I just had them off. I used an air powered wire wheel to clean the back side of rotor and axle hub. They are perfectly clean. By the way I had Ebc's on the front and they where warped to high heaven.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top