mine broke.....
mechanics wire wrapped around the place it used to clip over, i used the inside of a 2 piece marr connector, wich is a small brass cylinder with a set screw. Connect the 2 together and adjust till its shifts in the correct spots.
it's kinda farmerish but it cost about a buck and works just fine.
mechanics wire wrapped around the place it used to clip over, i used the inside of a 2 piece marr connector, wich is a small brass cylinder with a set screw. Connect the 2 together and adjust till its shifts in the correct spots.
it's kinda farmerish but it cost about a buck and works just fine.
