DodgeTalk Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Harrison
Joined
·
2,103 Posts
Discussion Starter · #1 ·
What is the neon block used for in a RWD application? Did they use the same block for 4 cylinder liberties? or any other 4 cylinder RWD vehicles?
 

·
Harrison
Joined
·
2,103 Posts
Discussion Starter · #3 ·
I was wondering what type of tranny would work for a very future plan to use an SRT-4 engine in a RWD application. But I have been pretty much shut down on another forum. But I still believe that anything is possible if you set your mind to it!
 

·
Registered
Joined
·
1,302 Posts

·
Neon Master Mechanic
Joined
·
1,090 Posts
The SRT4 tranny may be a good idea for you b/c of it's LSD (04/05 only) and it's equal length axles. It is a hydraulic clutch setup so just be aware of that. Any 1st gen tranny will bolt up; and they are cable clutches. Much easier to mess with IMO. You could always throw an LSD of some sorts into a 1st gen tranny.

I am sure you know about the available gear ratios and what not.


Link to that info:
http://people.clemson.edu/~dacarso/trans.htm




And ya if it was the .org I find that sad. You all have no idea how many times I have wanted to ream someone for just crappy attitude or for just being a cocky ass. Bla.



So what are you wanting to power with the 2.4? Little kit car or a conversion of sorts?
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top