DodgeTalk Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I know this questions has been asked 100's of times, but how many turns of the torsion bar bolts is too far and how high will it raise the fron end?
 

·
Up The Irons!
Joined
·
279 Posts
I'll get one in before all the "USE THE SEARCH FUNCTION!!!!!!" police chime in.

I believe most guys have found that 5.5-6 turns is about max they want to go because the truck sits level. Don't know if that's as many as they will physically go or not, but why would you go any higher? I went 3.5 on mine and it raised it about 1.5-1.75 inches. It still has a bit of a rake to it, which I like. I actually think they look sort of funny sitting level.
 

·
Registered
Joined
·
2,608 Posts
You can turn them all you want, but make sure you are level. We just did a truck that almost bottomed out one of the bolts while the other had a lot to go to keep the truck level.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top