DodgeTalk Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
240 Posts
Discussion Starter · #1 ·
Can anyone give me the torque specs for the plenum pan and also for the intake manifold itself? Thanks.

Eric
 

·
Registered
Joined
·
4 Posts
bolts 1-4 to 72 in lbs, in increments of 12 in lbs
bolts 5-12 to 72 in lbs
then all bolts to 12 ft lbs, check all of them in sequence

heres the sequence:

9 10
5 6
1 2
3 4
8 7
12 11

(front of engine here)
 

·
Registered
Joined
·
551 Posts
Actually your torque specs you have there are for the intake manifold. For the plenum the specs are
Tighten plenum pan mounting bolts as follows:
Step 1. Tighten bolts to 5.4 N·m (24 in. lbs.)
Step 2. Tighten bolts to 9.5 N·m (84 in. lbs.)
Step 3. Check all bolts are at 9.5 N·m (84 in. lbs.)
 

Attachments

1 - 4 of 4 Posts
Status
Not open for further replies.
Top