DodgeTalk Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I have a 99 Durango SLT 4x4. After reading several threads in this forum, I decided to remove the front sway bar to inspect and lube the bushings. I found a sticker wrapped around the sway bar slightly to one side that has what appears to be a part number and the word "LEFT" on it. This begs the question, how do you know the orientation of the sway bar? The ends are bent such that turning the sway bar over results in a slightly different orientation of the ends. I suspect the "LEFT" label should go to the driver's side, but it was not installed that way. Any ideas?
 

·
Patriot....
Joined
·
3,375 Posts
I'd just put it back in same way it came out. I took mine off when installing the Prothane bushings and didn't find any sticker.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Thanks, Kevin. That's what I did. Long story, short....a picture in the Haynes manual of the suspension showed the label (but couldn't read the writing on it) and it was to the left. The way I had removed it was this orientation after all.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top