DodgeTalk Forum banner

Status
Not open for further replies.
1 - 10 of 10 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter #1 (Edited)
I am looking at the edelbrock mild steel ceramics $359 vs the gibson $417 or jba $403 stainless non coated headers. obviously I'm looking to get an inexpensive but good product. I am willing to spend the extra for the stainless gibsons or jba's if they are a superior product.

I read that the edelbrocks use lead gaskets at the collectors to the y-pipes they me not be that reliable.

Any opinions?
 

·
Registered
Joined
·
22 Posts
is their seriously a diffrence between the type of material and brand ? I thought the point of headers was the space IN-BETWEEN the material.. You know what i mean?(air-flow)
 

·
02 R/T & 05 Ram
Joined
·
2,725 Posts
as long as they're coated, no. either will be fine.
 

·
Registered
Joined
·
62 Posts
Discussion Starter #5
I just orded the edelbrock ceramics from jegs........thanks
 

·
Registered
Joined
·
5,980 Posts
I think that the ceramics coat is better that the stainless steel.Last a bit longer and hold the heat better.
 

·
Registered
Joined
·
5,980 Posts
Manifolds what, good or bad or not.
 

·
Registered
Joined
·
124 Posts
BleedDodge said:
Manifolds.

the scavening on log manifolds sucks, but with some paience and a good carbide bit and some a afternoon, you can make them flow fairly well, but it also weakens an already prone to cracking part.
 
1 - 10 of 10 Posts
Status
Not open for further replies.
Top