DodgeTalk Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
If i buy the ring and pinion gears do i have to get a master install kit or can i use the old bearings and just get a new gasket and stuff?
 

·
Registered
Joined
·
1,006 Posts
I believe you need to set the clearances with shims

improper clearances will cause premature wear and the unit will howl like a banshee
 

·
Registered
Joined
·
1,231 Posts
I was under the impression you needed the master kit mainly because if you were that far in you want to replace bearings anyway. You need the shims for proper shoe wear. And lastly because...and here is the part that scares me...the new crush collar. Now I know with proper dial guages and such this is easily accomplished..but still for me it is intimidating.
http://ramchargercentral.com/index.php?action=howtoshow;id=13
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top