DodgeTalk Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Registered
Joined
·
441 Posts
Discussion Starter · #1 ·
I have the Superlift 2" coil springs on my truck and it always felt like it was a bit higher in the front, so I decided to measure and its about 3/4 to 1" higher in the front now.....not a big deal, but I would like to lift the rear up an inch. I have been looking around for a 1" block, but I read that our trucks already have blocks from the factory.....so, my question is, should I get a 1" block or measure my factory block and get one that is an inch taller?
 

· Registered
Joined
·
441 Posts
Discussion Starter · #4 ·
Where would I find "dead leaves" at?
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top