DodgeTalk Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi Everybody -
I am the owner of a 2002 Chrysler sebring coupe LXi (although its a 2002 it was produced in 2001. I just got an RB4 navigation unit for my car, and I am having some problems with it - First off the back lights on the buttons at night don't seem to work. Now I did have to buy an adapter (mopar part) for the two 7 pin connectors to go to the 22 pin connector on the back of the RB4, and I found out that pin 3 of the 22 pin connector is the one that controls the back light. So I unhooked that wire from the 7 pin connector part, and I hooked it up to an alternate power source (cigarette liter) and the back lights do go on for a second, but then turn off once the car is in the on position. I was hoping someone out there has installed an RB4 into an older car using this adapter and can tell me what I can do to get the backlights working. Thanks so much
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top