DodgeTalk Forum banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
PAID OFF!!!
Joined
·
7,637 Posts
Discussion Starter #1
I'm going to remove my radio tonight, so see if can get to my blender door squeak.

Is there any special tools or tricks I need to know or know about? Or will basic tools take care of it?

Thanks

Btw it is just the base stock radio.

Sent from AutoGuide.com Free App
 

·
Registered
Joined
·
357 Posts
Phillips screwdriver should be the only tool you will need. Sometimes a prying tool can be helpful, but gotta be careful not to tear up the trim if you pry with anything
 

·
PAID OFF!!!
Joined
·
7,637 Posts
Discussion Starter #4
Thanks to those that helped. Unfortunately I couldn't get to the squeak, but it hasn't shown itself in a few days, so maybe it fixed itself ?

I did have something interesting though. When I removed the dash bezel there were for wire connectors plugged into the dash. There were no female receivers on the other side, just male connectors in the dash. Anybody know what these go to. Heated seats maybe?
 

·
Registered
Joined
·
357 Posts
Most likely. It appears that most of the wiring gets installed no mater what model, and then they just don't use the parts you didn't get the options for.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top