DodgeTalk Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
167 Posts
Discussion Starter #1
Heres a pic of my motor, but i need some help. Where can i get the bolts for the Mopar Performance valve covers and what else do i need to be able to connect the pcv valve and the hose on the other side? Also anybody tried any header paint? i used one but it looks like a primer color im lookin for something more like aluminum. Thanks
 

Attachments

·
Registered
Joined
·
842 Posts
Motor looks good. Not sure about the PVC question, When I got my MP covers they had only one hole it them (for the filler caps)
 

·
An Army of One
Joined
·
1,227 Posts
Now that is a red engine!
Look s awesome
The PVC valve should fit into the gromet, and it is a 90 degree
angle, and then run the hose to the side of the manifold
 

·
Registered
Joined
·
584 Posts
I would send the headers out to have them ceramic coated. Will put a shine on them and they will dissipate heat from the engine compartment. Won't rust. Engine looks great.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top