DodgeTalk Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1 (Edited)
Help anybody know where the gray wire goes from the + side of the coil? I'm not getting to it and I don't want to tear the wiring harness apart to find it. I put a new ignition switch on the column and a new fuel pump relay in it. It doesn't get power to the fuel pump. The truck sat for 13 years. I ran a jumper wire from the batt. To the coil and put gas in it and drove it home. But can't figure out why I don't get power to the fuel pump without the jumper wire. And I ck. All the fuseable links and there all good so are all the fuse's. I'm at at lose as where to go next.
 

·
Registered
Joined
·
1,388 Posts
some more info on the truck would be nice like what year it is. the only thing i can suggest is to check asd relay
 

·
Registered MOPAR User
Joined
·
9,350 Posts
Not sure where it is on the 1st gen ram, But that is what I was going to mention. I heard these are the larger relay in power distro center
 

·
Registered
Joined
·
10 Posts
Discussion Starter #6
Well I fixed it. The rod from the key to the ignition switch wasn't seated all the way into the switch. And now it starts and runs.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top