DodgeTalk Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
151 Posts
Discussion Starter #1
well I have a 2007 2500 6.7L 4x4 and when i bought it the truck had a aftermarket Karr alarm on it. Well the thing has constantly been a pain in my ass. So I decided to take it out today. well... safe to say i got all the hardware out but now i have an issue.

when i turn the key over.... everything comes on... but when i try to start it... the engine wont turn over. Which im assuming means two of the wires for the ignition system were cut in this cluster **** under my dash.

Does anyone have a wiring schematic for the ignition system so I can find the wire in question????
 

·
Registered
Joined
·
151 Posts
Discussion Starter #2
looks the only wire that isnt where its supposed to be is the purple/brown comming off of the ignition. its been cut and Im not sure where its supposed to go
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top