DodgeTalk Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
135 Posts
according to the manual; adjust the mirror so the glass is angled in towards inside of cab. You can see behind the glass where two clips holding the rear outside plastic of mirror housing are attached. you can pop two of the three total clips this way and with the back of the mirror housing off you can see the back of the motor assembly. There is a small clip at bottom of motor that the glass attaches to. Pop that clip then slide the glass up and off.

Good luck

Standard Mirror
(1) Position the mirror glass so that it’s facing in
toward the vehicle as far as possible. (Fig. 16)
(2) Disengage the rear housing cover retaining
tabs and remove the cover. (Fig. 17)
(3) Disengage the lower glass retaining tab to
motor. (Fig. 18)
(4) Slide glass up and remove from motor.
(5) Disconnect the two heated mirror electrical
connectors, if equipped.
 

Attachments

1 - 1 of 1 Posts
Status
Not open for further replies.
Top