DodgeTalk Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
287 Posts
Discussion Starter #1
Well my 2nd Intake manifold gasket went out...looks like i will be going to lucky number 3...The first 2 times it was done at the dealer since it was under warranty..first at like 20-30k then at 50-60k, and now at 84k it needs another..This time i will be doing the work myself, and buying a Good gasket, not the cheap mopar ones. While my Intake and throttle body is off, i will also be porting and polishing them, so i should see a little better power increase..i'll let you all know how it goes.
 

·
pakrat
Joined
·
18 Posts
Are you talking about the intake plenum plate gasket? or the intake to head gaskets going out? Hughes engines inc sells a machined alluminum plenum plate that is much better than the stock stamped steel plate. Check them out.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top