[racenut]

This is on an 05 red cab 1500 ram. I had 2" drop coils and a flip kit out back. Had that for like 10 years. But always wanted lower. So. I needed ball joints. So now was the time. I got 3" DJM lower control arms. And I cut 1/2 a coil off my stock springs. And just used stock rear hangers out back. I am at 4/6. Yes I have a "C" knotch for back. Just haven't cut n put n yet. Just did the relowering today.

My Q is. The inner tierods r very close to hitting the frame. What r my options? It's close to hitting the front side of the spring bucket. The front brace for it.

Thanks

 

[RAMaLEX]

in for pics lol

 

[ECONORAM]

I don't know much about a 4/6 drop, but if you didn't already, search in some of the older threads. I know there were several folks that have done a 4/6 drop, and they might have the answer.

 

[racenut]

What I have Dunn is. Flip the tie rod ends. Had to ream spendel from bottom to do this. Gave me the clearance I needed. But now have ran out of adjustment on my tie rods. So need to cut them a lil shorter.

 

[ECONORAM]

Tried to find a few threads to help or with pictures that might help. May also finally persuade me to do a drop. . . . sometime.

4/6 drop stuff

http://www.dodgetalk.com/forums/showthread.php?t=618873&highlight=drop+4+6

http://www.dodgetalk.com/forums/showthread.php?t=552009&highlight=drop+4+6

Some tire choices: http://www.dodgetalk.com/forums/showthread.php?t=506321&highlight=drop+4+6

Shikity might be able to answer your questions if he’s still around.
http://www.dodgetalk.com/forums/showthread.php?t=479354&highlight=

http://www.dodgetalk.com/forums/showthread.php?t=491329&highlight=drop+4+6

http://www.dodgetalk.com/forums/showthread.php?t=473746&highlight=drop+4+6

Nice picture of a bolt in C notch: http://www.dodgetalk.com/forums/showthread.php?t=460289&highlight=drop+4+6