DodgeTalk Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hi,
I'm wondering if my control arm bushing has more play in it than normal. My truck wobbles at 55mph and when I brake. I just replaced the rotors and it isn't a consistent pulsing when braking but rather an unpredictable shifting. My wheel hub bearings felt tight when I replaced the rotors and did not notice any wear in ball joints or tie rods. My steering rack is wet underneath by the drain plug but no dripping or any tears in the boots. I plan on getting my tires balanced but I doubt anyone in town has a road force balancer. Also my front CV axles have a lot of wiggle movement where it enters the differential but there is no leakage and the video doesn't show it wobbling off center.

Here's a video of the bushing while turning the wheel back and forth.
https://youtu.be/VA21XiiTwEE

Here's a video of me driving and you can see a lot of movement in the bushing when I pull off the road at the end of the video.
https://youtu.be/4kiaNtMyTmM

Is that excessive movement?
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top