DodgeTalk Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter · #1 ·
Hey Y'all.
I have just bought my 4bbl M-1 MPI intake manifold and i have been part fitting. Most every thing seems to fit like factory. I don't even need to clearance the A/C bracket to fit. It is about 3/8's taller though. Any way, the injector journals look larger and that brings me to my question. What if i open that area even more. Say round the edges and allow a better spray pattern?
 

·
Registered
Joined
·
56 Posts
Discussion Starter · #3 ·
Oh i have ported the intake runners and cleaned the edges and polished the inside of the intake. It is the actual journal that the injector sits in that i was wondering about. It has the machine polish from when the hole was cut. It just occurred to me that if i opened the outlet side up a bit it would interfer with the fuel cone a bit less.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top