DodgeTalk Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
549 Posts
Discussion Starter · #1 ·
Ok, I'm planning a Viper T56 upgrade in my Hemi Ram. Are yall running stock master cylinders and throw out bearings? I have been trying to do some research and have seen mention of upgrading to a viper hydraulic set up?

I figured I could use a stock SRT-10 Ram set up since it should bolt right up to my Ram.
 

·
Registered
Joined
·
2 Posts
I was collecting up parts to do this install as well BUT have since quite on it I have a few of the goodies if you are interested I have a shifter from the truck srt-10 and the clutch master cylinder
 

·
Registered
Joined
·
549 Posts
Discussion Starter · #4 ·
Is the shifter a B&M or Hurst? I'll take it if it's a Hurst.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top