DodgeTalk Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
2,243 Posts
Discussion Starter #1
Anyone know the part numbers from Gates for my tensioner unit with pulley, and the 2 idler pulleys? I was on Ebay and it had like 4 different part numbers that says "Direct fit for 2003 dodge ram 2500". wtf?

Any help appreciated, thanks.

FYI: My tensioner pulley is grooved, idlers are not. They show both. ????
 

·
Registered
Joined
·
2,773 Posts
Go with OEM on the tensioner, I have aftermatket and then went to oe after my underdrive pulley install. Idler pulleys I went with dayco steel ones. Got them at advance.
 

·
Registered
Joined
·
2,243 Posts
Discussion Starter #3
Ok thanks. I'm trying to keep the price down a little, and the OEMs are like twice the gates arent they? I don't even know a part number yet. Thanks. I'll look into the idler pulleys.
 

·
Fathead
Joined
·
1,046 Posts
get the steel gates ones with no grooves... I went through rockauto.
 

·
Registered
Joined
·
2,243 Posts
Discussion Starter #5
So the Tensioner pulley does need to be grooved? Because my factory one is.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top