DodgeTalk Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Are there any special steps needed to remove the rear rotors on an 99 Intrepid? I was a changing the pads and the rotors and had a hard time getting them off. I assumed I could pull them all like the front. Am I wrong, is there something else involved? Thanks!
 

·
Do It In A Van
Joined
·
8,045 Posts
Sometimes the rotors use two countersunk phillips screws around the hub area to hold the rotor on.
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
Wanted to give an update. I used a rubber hammer to 'wack' the rear rotors a couple of times until the rust deposits were broken. After aa couple of good hits, the rotors came off.
 

·
Do It In A Van
Joined
·
8,045 Posts
Cool!
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top