DodgeTalk Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter #1
I'd like to go to 4.10s on my 3/4 ton V10 2wd, it has 3.55s as of now. Not being too familiar with rear ends my mechanic told me I may need a new carrier for the 4.10 gears. Is this correct? Also what's the best way to correct the speedo after it's done? Thanks
 

·
REDNECK SPACESTATION
Joined
·
5,543 Posts
I don't think the 3/4 has the 9.25 rear end, but I don't think you would need to change carriers.
He may be trying to milk you, I know 4.10 was an option on our trucks, but I think the rear end was the same model.
 

·
Registered
Joined
·
43 Posts
Discussion Starter #3
Found out that I have the Dana 70 and I don't need a carrier change until I go numerically higher than 4.10, so I should be ok.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top