DodgeTalk Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
DFFL
Joined
·
1,219 Posts
Discussion Starter #1
How do you get the little plastic screws out of the headlights where it holds the rubber onto the metal. Any tricks on taken the headlights out?
 

·
Registered
Joined
·
3,953 Posts
3 torx screws and a yank.
 

·
Banned
Joined
·
3,902 Posts
What about the clip on the back of the headlight?
 

·
DFFL
Joined
·
1,219 Posts
Discussion Starter #4
So what do you grab them with?? , I see the ones you have to actually have a ratchet whatever but the other ones you yank, so they dont break or what. Also which bulbs are brighter the ones they send withe the clear corners or my Piaa Superwhites??
 

·
Registered
Joined
·
3,953 Posts
Clip? You mean the wire pigtail to the lights? That has enough slack to diconnect after the yank. As for the screws, there are two very visable under the grill and one underneath toward the outside. Be sure not to scratch your bumper cover if your sport. After removing these three I just yanked on it until it came off in my hands. Then I diconected the wire. I used the bulbs provided so I can't help with that.
 

Attachments

1 - 5 of 5 Posts
Status
Not open for further replies.
Top