[dodgerider666]

I know there are a few people on here that have done this a few times I've only done it once and it was on a very old dodge. I didn’t have any problems after it was gutted and the engine and tranny where out although when I lifted the cab off I had the help of a off road forklift and a big chain. As for painting the frame I would highly recommend you don’t use paint I would go with Rust bullet I've heard many good things about it. I know summit it has it if you can’t find it elsewhere.

GL :gr_patrio

 

[dodgerider666]

I've heard good things about the rust converter as well so that should be good as for the enamel paint I was always told it dries to a hard usually glossy finish. As for the epoxy primer I don’t know if that will work never tried it and don’t know of anyone who has. I think if I remember right you can use the rust converter and a rubberized undercoating but I could be wrong.