DodgeTalk Forum banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Banned
Joined
·
3,902 Posts
Discussion Starter · #1 ·

·
Banned
Joined
·
3,902 Posts
Discussion Starter · #2 ·
Also, what could I put on my crosspipe going between my cats to keep it from rattling at idle?

Would pipe insulation work, or would it melt???
 

·
Banned
Joined
·
3,902 Posts
Discussion Starter · #4 · (Edited)
ridehardny said:
I have a 3 inch slip on turndown if you're intrested.
Got a pic? Send me a PM.
 

·
Registered
Joined
·
373 Posts
Here's the pic. I also have about 2-3 feet of 3 inch pipe, and I believe 3-3inch clamps. The clamps have surface rust on them. They were on my truck over night only.
 

·
Banned
Joined
·
3,902 Posts
Discussion Starter · #6 ·
Thats not what I am looking for. I need it to be able to bolt on the front of the cutout like in pictures in Post #1.
 

·
Banned
Joined
·
524 Posts
so you need one welded on to an exhaust flange....most muffler shops have old manifolds and stuff laying around, you can have thhem cut that and weld a dump to it
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top