DodgeTalk Forum banner

Status
Not open for further replies.
1 - 20 of 21 Posts

·
Registered
Joined
·
280 Posts
Discussion Starter #1
Anyone know what P 0133 is ?
 

·
Registered
Joined
·
280 Posts
Discussion Starter #3
What is that in English?
 

·
Registered
Joined
·
280 Posts
Discussion Starter #6
OK,Thanks. Maybe someone else will read this and be able to tell me for sure.
 

·
Registered
Joined
·
29 Posts
replace the o2 sensor on the driver side top one
 

·
Hotty Toddy Gosh Almighty
Joined
·
5,101 Posts
Yup, bad O2 sensor. Nothing too serious, as they are a maintenance item and will eventually wear out.
 

·
Registered
Joined
·
280 Posts
Discussion Starter #9
What is the degree of difficulty to replace it on a scale of 1 to 10 with 10 being th hardest?
 

·
Hotty Toddy Gosh Almighty
Joined
·
5,101 Posts
Not even 1. Could be a 10 if you don't have a wrench.
 

·
Registered
Joined
·
532 Posts
LMAO!!!! What about a socket no ratchet?
 

·
Hotty Toddy Gosh Almighty
Joined
·
5,101 Posts
Thats a 9, cause you can get creative.
 

·
Registered
Joined
·
532 Posts
I can accept that! LOL Hey just a quicky what's the 1.5" Torsion Bar Crank listed in your mods?
 

·
Registered
Joined
·
532 Posts
Oh yea nice avitar!
 

·
Registered
Joined
·
73 Posts
A socket won't work because of the wires. I think it's a 7/8 open wrench that fits those. I little tip. Spray some WD40 or some other kind of "break free" lube a wait for a couple minutes. The sensor will loosen much easier that way. Good luck.
 

·
Hotty Toddy Gosh Almighty
Joined
·
5,101 Posts
slambony said:
I can accept that! LOL Hey just a quicky what's the 1.5" Torsion Bar Crank listed in your mods?
Its where you tighten the torsion bar adjusting bolts thus increasing the preload on the torsion bars which results in it lifting the front end higher.
 

·
Hotty Toddy Gosh Almighty
Joined
·
5,101 Posts
slambony said:
Oh yea nice avitar!
Thanks, its my old girlfriend from Oklahoma. I took her out for some modeling photos one time for her birthday.
 

·
An Army of One
Joined
·
1,227 Posts
Those O2 sensors aren't cheap, got one when i had the exaust put on and right at $70 at Advanced, but I didn't have a chance to shop around!
 

·
Registered
Joined
·
532 Posts
Old girl friend Yea? So you just cranked it in to lift 1.5" I thought it was something eles sorry. P.S. heloace they make a socket with a slot for the wire to go thru J.M.O. :D
 
1 - 20 of 21 Posts
Status
Not open for further replies.
Top