[07Whiteram]

anyone know how to disconnect the primary fuel line?? i have the tool BUT its not dissconnecting??

 

[shuencl]

where are you trying to diconnect it from?

 

[07Whiteram]

from the 2 fuel rails on top of the manifold!!

 

[shuencl]

pretty much all you have to do is push the tool up on the line and pull the fuel line and it should come off it took me a some time to get mine off.
hope this helps.

 

[crazeejay]

Just make sure the tool is in all the way, then jiggle it and pull at the same time. Mine took about 5 minutes before it popped off.

 

[darell_n]

I bought a cheap, generic fuel line tool that needed to be trimmed to work properly. That may be your problem, too.

 

[383HEMI]

^Yep, what they said ^

 

[daytona-dude]

mine was tough to get off as well. just keep working at it, it will come off

 

[dayton hemi]

wd40

 

[HEMI450HP]

I fought with mine the 1st time as well...after that it was easy.

 

[07Whiteram]

ha ha ha took about 10 mins of playing and jiggling before it worked finally!!! thanks for the help!

 

[383HEMI]

ha ha ha took about 10 mins of playing and jiggling before it worked finally!!! thanks for the help!

 

[crazeejay]

ha ha ha took about 10 mins of playing and jiggling before it worked finally!!! thanks for the help!

You're talking about the fuel line right?

 

[chefred112]

...why are you removing fuel line?..new injectors?

 

[hemidup]

...why are you removing fuel line?..new injectors?

He's pulling the heads to change the springs. I'm sure he's leaving the fuel rails attatched to the intake manifold.

 

[07Whiteram]

He's pulling the heads to change the springs. I'm sure he's leaving the fuel rails attatched to the intake manifold.

yes he is!!! and yes im talking about the fuel line ha ha ha

 

[chefred112]

o ok.. in the 20+ cam/head installs I've been involved with...never pulled or disconnected the fuel lines, that's why i'm askin...

 

[ramcrazy]

How is this going??? Did you find the correct springs yet? If we just knew a few days ago I would have sent you the right ones overnite....... Please keep us posted of how it is going!!!!!

 

[hemidup]

o ok.. in the 20+ cam/head installs I've been involved with...never pulled or disconnected the fuel lines, that's why i'm askin...

So Fred, What do you do with the fuel rails?

 

[chefred112]

we loosen the intake manifold (in most cases not removing all the way) jus to get to the upper head bolts and usually keep the intake up with a bungee cord... and not touching the fuel rails..