DodgeTalk Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I bent the hell out of my crossmember supporting my trans on my 01 1500 Ram. Someone at a salvage yard claimed I could use one from 94-01. Is this correct? Does engine size and man/auto trans matter? I hate to part with $300 for the dealer.
 

·
GROUNDED
Joined
·
2,944 Posts
is it 2wd or 4wd? If its 2wd get the belltech tranny x member from summit...it runs just over 100 or if its 4x4 just make one using the end plates.
 

·
GROUNDED
Joined
·
2,944 Posts
eek. check with djm or belltech they may have one for a manual trans. other then that i would fab one up. its a quick job and could cost way less then 100.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top