DodgeTalk Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
85 Posts
Discussion Starter #1
I got a 95 2500 v10 and i want to get a cold air intake - but i got wanna spend like $250 on it. Is there anyway i can make it without buying one?
 

·
******* SPACESTATION
Joined
·
5,543 Posts
get an open element setup.
Flows better and costs a lot less.
 

·
EPA's Worst Nightmare
Joined
·
1,673 Posts
It's possible and I would rather do it than buy one like I did. The problem is the V10 will be a little trickier to make than one on a V8 like chizzle has. Actually almost impossible.
I attached a few pics of my CAI, TB, and manifold to explain better. All you would really need to do is attach a pipe to the TB and run it to the front of either the passenger or drivers side. I think the only reason K&N goes to the right side is because the batt is on the left. K&N CAI for the V10 seems like it is designed poorly and cheep IMO.
 

Attachments

1 - 4 of 4 Posts
Status
Not open for further replies.
Top