DodgeTalk Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
2wd Dak, 4X4 soon
Joined
·
339 Posts
Discussion Starter · #1 ·
I changed my plugs and wires recently but the conection between the coil and wire is bad and doesn't seem to fit right. If I push it on it runs good but then after a few miles it starts missing again so I push it back on.

Should I just crimp the connector a bit to tighten it up?
 

·
Registered
Joined
·
98 Posts
which wire are you having trouble with on the coil the plug/coil wire? or the connection wire at the bottom, sometimes when that connection wire gets hot it can cause it to misfire i had to unplug it..kind of a reset, i just ended up buying a coil so far so good, no missfire
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top