DodgeTalk Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
recently i have notice that when accelerating like going up hill or passing the power is like slugish and jerks once then takes off i have no light on dash but i decided to hook up scan reader and i get code PO740 then PO 700 if i remember right the 700 code is like a generic code and ik for the 740 code its converter clutch silanoid if i am right so i was wondering if i should replace that or is there something else that could through the codes thanks in advance
truck is a 05 dakota quad cab 4.7 engine / auto transmission
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top