DodgeTalk Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have a 1997 Dodge B-350 van with a 360 motor automatic transmission with 253,000 miles on it. I keep on pulling code P0171 system to lean ( cylinder bank no. 1 ). Just before this code started coming up I changed the converter, o2 sensors, iac, camshaft position sensor, crank sensor, plugs wires cap and rotor, injectors, and the ecm. I need to get this thing to pass the NY State inspection.
Any help would be greatly appreciated.
Thanks
 

·
Registered
Joined
·
266 Posts
My bet goes with vacuum leak. Something is letting too much air into bank #1 and your bank one 02 sensor is reporting that. Look for a loose, broken or disconnected vacuum hose AND if you don't find a problem there, have it checked for leaking plenum gasket. A leaky exhaust system BEFORE the front 02 sensor can set this code also. At worst, with 250000 plus miles you may have a mechanical problem-broken rings or what ever. Look for that with a compression test. BTW its not impossible to have a bad new 02 sensor, it happens. HTH
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top