[hopper16]

I just installed new master and slave units... by the book, I cut the plastic tabs off the slave after everything was installed and now i have no pressure in the clutch pedal. I believe the problem is in the aluminum/connector that plugs into the slave unit, not sure but it seems to be connected good, not really sure how fluid gets past that point. do i need to bleed the system at all?

 

[ltl grn trk]

when replacing the slave /master cylinder you don't cut the strap off the
slave clyinder. just install the slave cyl, the strap will snap off when you engauge the clutch

 

[Charged_dak]

i just replaced my slave not too long ago also you dont cut the cap off keep it on and to bleed your slave is a pain you have to pump the clutch until you gain pressure, i pumped mine for like an hour in a half non-stop before i got any pressure out of it.