DodgeTalk Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
66 Posts
Discussion Starter #1
Ok, so I went to lube the chassis for the first time, and only found 3 grease fittings. This sounds odd, so I talked to a mech about it. told him that I am sure there are more, and around the chassis points there are these little covers over one end. I cleaned them off and they seem to be plastic, but i dare not remove them for fear of breaking on and ending up paying out the A$$ later. He also said that if their not visable don't worry, just use a little WD40 on the rubber components, is this valid info too?
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top