DodgeTalk Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Has anyone replaced the camshaft oil seal? Is it easy? Do you have to remove the timing belt or can you just remove the sprocket and have someone else hold the belt under tension while you remove and replace the seal? My van has a 2.5l turbo 4. :help:
 

·
Do It In A Van
Joined
·
8,045 Posts
I think you can get the seal on by just removing the camshaft sprocket.

Use some tie-wraps (zip-ties) to hold the belt to the pulley. Be sure and keep tension on the belt or it may slip off the crankshaft gear and then you'll have to tear the whole thing down and reset the belt.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top