DodgeTalk Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
111 Posts
Discussion Starter #1
came across a goot deal on a set of upper ands lower djms... has anyone tried useing them in combo with spindles? just wondering if i'll run into problems when flipping the balljoint... if not i suppose i'll go pick em up :rck:
 

·
GROUNDED
Joined
·
2,944 Posts
im gonna run mine with a belltech spindle. im actually gonna mount them upside down on either side because there is a flat plate onit that im gonna bolt my bag to. you need to trim some metal out to clear the bar on the back of the lca so jack it up as high ans possible and where it hits, cut.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top