DodgeTalk Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
146 Posts
Discussion Starter #1
I saw the closed thread about putting 20"rims on a '99 Ram, which is what i want to do. I found a set of 13/16" Acorn nuts for 1/2-20 studs, Would I be better off using the 3/4" bulge nuts? The seat area appears to be about the same, although the bulge is much bigger than the 13/16 hex (appears to be about 7/8). The contact area on the bulge nuts I was temporarily using looks to be about the the same size as the shoulder of the acorn nut. Thanks for any help!
 

·
Registered
Joined
·
146 Posts
Discussion Starter #3
Thanks for your reply. EZAccessory is who I got the 13/16" Acorn nuts from, so I'll write/call them and see if they have a bigger Bulge nut for 1/2"20 studs. Anyone else out there got any ideas/suggestions?
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top