DodgeTalk Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1,006 Posts
Discussion Starter · #1 ·
1984 D100 w 318 and 3 spd + OD manual gearbox

pulled the al;eternator off while doing the timing chain

normally very careful about marking and noting which wire goes where - except this time

one wire goes on a post terminal secured with a nut - that is clear

there are two other wires with spade terminals - one wire is red and the other looks white but according to the Haynes manual wiring diagram is light green I believe

There are two terminals on the alternaor - this is going to sound dumb but it is the only way I can explain it - one is closer to the post terminal and the other is further away

Which one doe the red wire go on

Once i Know that, my little brain can figure out which terminal the white and/or light green goes on

thanks for your help in advance
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top