DodgeTalk Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Okay so last week I put in a new radiator, plugs, wires, cap and rotor. Also
a new thermostat and new housing.

I noticed that my intake manifold gasket was leaking and I had to get it replaced.

Now I have a few more issues to get straight.

I am changing the water pump, temperature sensor for the gauge and fix my rear end cover is leaking (going to pull it, clean it and place it.

However I have noticed some thin whitish smoke when starting. It only last for a few minutes and then is gone. My thoughts are that if it were a head gasket that it would smoke heavier and would not stop after a little while of running.
Any ideas or things for me to check?
I did not change the intake manifold - i had a shop do it -- could it be something they did?

thanks
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top