DodgeTalk Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter · #1 · (Edited)
went to drive to work today and pushed in the ckutch and it would not go into gear... it was ok last night no slipping of the clutch.. i crawled underneath the truck and all i can see that could be wrong is that the clutch linkage is warn by the rod for the clutch adj. anyone have any other ideas as what could be wrong.. oh yeah the clutch pedal seems to be very spongy and takes little force to push it to the floor..

Thanks
 

·
Do It In A Van
Joined
·
8,045 Posts
You could have a throw out bearing going bad. Try adjusting the clutch.
 

·
Aka Force Fed Mopar
Joined
·
6,120 Posts
maybe the fork slipped out of place?
 

·
Registered
Joined
·
39 Posts
Discussion Starter · #4 ·
Thanks Speed Dragon you were right on the money :D the fork came off inside the belll housing

thanks again
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top