DodgeTalk Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
I have a motor our of a 1996 dodge cargo van, same 5.9 as in trucks, that im transplanting in a 84 d150. I need a ecu pinout diagram for the fuel pump so I can install a inline fuel pump. If im correct this engine needs about 40psi fuel pressure and is returnless. I could also use a pinout for ignition too. I have all wiring that came on engine and wiring but lack a harness for under dash, hence my problem. Thanks for any help.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top