DodgeTalk Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
I have a motor our of a 1996 dodge cargo van, same 5.9 as in trucks, that im transplanting in a 84 d150. I need a ecu pinout diagram for the fuel pump so I can install a inline fuel pump. If im correct this engine needs about 40psi fuel pressure and is returnless. I could also use a pinout for ignition too. I have all wiring that came on engine and wiring but lack a harness for under dash, hence my problem. Thanks for any help.
 

·
Registered
Joined
·
1,621 Posts
fuel pressure sounds right. i will look in my hayne manual to see whats in there about the wiring, but if i were you, i'd run down to the local parts store and flip thru the books. see if any of them have what you need.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top