DodgeTalk Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter · #1 ·
i have a 98 ram and my 4x4 light was not going out but it didn't feel like it was still engaged so i thought it was a bad shift switch. But the other day i changed my wheel hubs and i seen the the axle's were still engaged . I would roll my wheel and the front drive shaft would turn and the transfer case was in 2h. What do you guy think it could be the shift motor or the fork.
My gas mileage has gon down to.
 

·
Built Not Bought
Joined
·
1,870 Posts
Its your CAD unit. Check to see if any of the vacumn lines going to it are broke, or came loose
 

·
Built Not Bought
Joined
·
1,870 Posts
Central axle disconnect. Look atthe right side of your front axle, Youll see a bunch of vacumn lines running to it.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top