DodgeTalk Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter · #1 ·
I have seen in a few posts that some 408's needed to mod the fuel rail. I was wondering if anyone had any Wisdom as to this. i was thinking of capping the origanal inlet to the rail and Y'ing the cross over line. Do y'all think that would be good enough? I am not running to much of a radical set up. Upped the stock injectors to 21#. No NOS or SC. I have heard that the starboard side would run lean. So it would seem to me if i Y'd it it would pull even eh?
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top