DodgeTalk Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter · #1 ·
I have seen in a few posts that some 408's needed to mod the fuel rail. I was wondering if anyone had any Wisdom as to this. i was thinking of capping the origanal inlet to the rail and Y'ing the cross over line. Do y'all think that would be good enough? I am not running to much of a radical set up. Upped the stock injectors to 21#. No NOS or SC. I have heard that the starboard side would run lean. So it would seem to me if i Y'd it it would pull even eh?
 

·
Registered
Joined
·
434 Posts
The stock crossover is to small for most 408's.

If you Y it, it could be OK I'm just not sure. I'd check your AF on both sides or at least check your exaust gas temps on both sides to be sure there at least even.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top