DodgeTalk Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
Can someone help me I have a 2009 ram with the hemi 4x4, and the 4x4 light usually flashes 2 or 3 times and it goes into 4x4. The light is continously flashing and not going to solid light... meaning 4x4. The truck does go into four wheel drive but there is a reason the light does not indicate the shift is complete. Please help. Thanks for your advice.
 

·
Registered
Joined
·
187 Posts
Try taking it back to 2wd first and wait for the light to go out. Then try 4wd again. Also make sure you unload the tranny meaning very little throttle or no throttle and barely let it roll at a slow speed. There is likely a procedure in the manual for taking it in and out of 4wd but this is what I do and it always works fine for me.Some times I also slide the tranny into netural then back to drive to make it engage fully.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top