DodgeTalk Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello Dodgetalk I'am a new member and this is my first post. Names Angelo and I'am from South New Jersey. I have an 08' Dodge Ram 3.7L V6 and I've been wanting to clean my throttle body but apparently I cant figure out how to take the resonator box or the cover with 3.7L V6 ingrave in it. Any help with removing this piece. I'am fairly new to fixing up my truck so if any parts I get wrong or questions sounds dumb sorry about that.
 

·
Admin - David Mack
Joined
·
30,924 Posts
Welcome to DT!

I've not worked on the 3.7L engine but I'm sure the engine is much like the one that's on the Jeep. I have K&N install sheet and the first part should help. The file is too big to post so here's a picture of that page in the attachment.

Click on the link for cleaning the TB...
How-To: Clean Throttle Body (Staging Area)


:dtrocks:
 

Attachments

·
War Eagle!
Joined
·
2,005 Posts
from my memory when I installed my CAI remove the air box and the clamp on the TB and it should pop right off....it may have a single bolt holding it on hidden by the air box but I can't recall
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top